Aradığınız malzemenin ürün kodunu ya da ürün tipini yazarak ilgili ürünün detay bilgilerine ulaşabilirsiniz.

Örnek:








  • Single band 2.4GHz IEEE 802.11b/g/n
  • 72.2Mbps receive PHY rate and 72.2Mbps transmit PHY rate
    using 20MHz bandwidth
  • 150Mbps receive PHY rate and 150Mbps transmit PHY rate
    using 40MHz bandwidth
  • Low power consumption & excellent power management
    performance extend battery life.
  • Easy for integration into mobile and handheld device
    with flexible system configuration.
  • Serial Interface : UART
  • UART Max Baud : 921600 bps
  • Soft AP
  • Enough memory retention
  • Wi-Fi Security (WEP, WPA/WPA2PSK)
  • L2 Switching
  • OTA(Over The Air F/W Upgrading)









  • - Single band 2.4GHz IEEE802.11b/g/n Wi-Fi module
  • - Integrated RF power amplifier : Antenna calibration is not required
  • - 1MB flash memory, 128KB SRAM, 1MB serial flash
  • - Low power consumption
  • - The highest compatibility with the most of APs
  • - Compact size, suitable for mobile or hand-held devices
  • - Host Interface : UART , SPI
  • - Support powerful web configuration
  • - Soft AP (Enough memory retention, L2 switching)
  • - OTA (Over the Air F/W Upgrading)
  • - Wi-Fi Direct








  • - Extereme Low Cost
  • - 802.11 b/g/n Wi-Fi 2.4 GHz
  • - Support WPA/WPA2
  • - Support STA/AP/STA+AP operation modes
  • - Integrated 10-bit ADC
  • - Integrated TCP/IP protocol stack
  • - Integrated TR switch, balun, LNA, Power Amp. and Matching Net.
  • - Integrated PLL, regulators, and power management units
  • - Supports Antenna Diversity
  • - Support Smart Link Function for both Android and iOS devices
  • - SDIO 2.0,(H) SPI, UART, I2C, I2S, IR, PWM, GPIO
  • - STBC, 1x1 MIMO, 2x1 MIMO
  • - A-MPDU & A-MSDU aggregation & 0.4s guard interval
  • - Deep sleep power <10uA, Power down leakage current <5uA
  • - Wake up and transmit packets in <2ms
  • - Standby power consumption of <1.0mW (DTIM3)
  • - +20 dBm output power in 802.11b mode
  • - Operating temperature range -40ºC ~ +125ºC
  • - FCC, CE, TELEC, WiFi Alliance, and SRRC Certified
  • - 3.0~3.6V Working Voltage
  • - WEP/TKIP/AES Encryption
  • - IPv4,TCP/UDP/HTTP/FTP Network Protocols









  • - Low Cost
  • - 802.11 b/g/n Wi-Fi 2.4 GHz
  • - Support WPA/WPA2
  • - Support STA/AP/STA+AP operation modes
  • - Integrated 10-bit ADC
  • - Integrated TCP/IP protocol stack
  • - Integrated TR switch, balun, LNA, Power Amp. and Matching Net.
  • - Integrated PLL, regulators, and power management units
  • - Supports Antenna Diversity
  • - Support Smart Link Function for both Android and iOS devices
  • - SDIO 2.0,(H) SPI, UART, I2C, I2S, IR, PWM, GPIO
  • - STBC, 1x1 MIMO, 2x1 MIMO
  • - A-MPDU & A-MSDU aggregation & 0.4s guard interval
  • - Deep sleep power <10uA, Power down leakage current <5uA
  • - Wake up and transmit packets in <2ms
  • - Standby power consumption of <1.0mW (DTIM3)
  • - +20 dBm output power in 802.11b mode
  • - Operating temperature range -40ºC ~ +125ºC
  • - FCC, CE, TELEC, WiFi Alliance, and SRRC Certified
  • - 3.0~3.6V Working Voltage
  • - WEP/TKIP/AES Encryption
  • - IPv4,TCP/UDP/HTTP/FTP Network Protocols











  • - ESP8266EX Wi-Fi SoC + 8Mbit SPI Flash
  • - Extereme Low Cost
  • - 802.11 b/g/n Wi-Fi 2.4 GHz
  • - Support WPA/WPA2
  • - Support STA/AP/STA+AP operation modes
  • - Integrated 10-bit ADC
  • - Integrated TCP/IP protocol stack
  • - Integrated TR switch, balun, LNA, Power Amp. and Matching Net.
  • - Integrated PLL, regulators, and power management units
  • - Supports Antenna Diversity
  • - Support Smart Link Function for both Android and iOS devices
  • - SDIO 2.0,(H) SPI, UART, I2C, I2S, IR, PWM, GPIO
  • - STBC, 1x1 MIMO, 2x1 MIMO
  • - A-MPDU & A-MSDU aggregation & 0.4s guard interval
  • - Deep sleep power <10uA, Power down leakage current <5uA
  • - Wake up and transmit packets in <2ms
  • - Standby power consumption of <1.0mW (DTIM3)
  • - +20 dBm output power in 802.11b mode
  • - Operating temperature range -40ºC ~ +125ºC
  • - FCC, CE, TELEC, WiFi Alliance, and SRRC Certified
  • - 3.0~3.6V Working Voltage
  • - WEP/TKIP/AES Encryption
  • - IPv4,TCP/UDP/HTTP/FTP Network Protocols









  • - 802.11b/g/n up to 150Mbps 4 MAC Interfaces WiFi SoC
  • - Bluetooth Supports BR/EDR/LE Supports both Class 1 and 2 TX
  • - Xtensa LX6 dual-core up to 400 DMIPS Code size 15% smaller
  • - 500kB, 200kB for Users Internal Ram
  • - 4MB Instruction space Configurable Mapping Table for OTA
  • - 1.8V/3.3V Internal LDO for external Flash
  • - SD/eMMC/SDIO Host Support
  • - 4 SPI Controller
  • - 32 GPIO
  • - 2 UART with DMA
  • - LED PWM HW support, 16Ch., 20-bit timers at 80 MHz CLCK
  • - Motor PWM Pluse Counter Hardware
  • - Two 32-bit Timers & two 64-bit timers One 48-bit-RTC timer
  • - Two system Watchdogs and one RTC Watchdog
  • - 16-channel, 12-bit Supports Low Noise Analog Amplifier
  • - 2-channel, 10-bit DAC
  • - Support for Sleep Modes 32K Crystal
  • - 10 Ch. Touch Sensor
  • - Supports AES-128, AES-192 & AES-256 (FIPS PUB197)
  • - Supports SHA-1, SHA-256, SHA-384 & SHA-512 (FIPS PUB180-4)
  • - Supports 512-bit to 4096-bit RSA Encryption
  • - 8 kBytes, Instruction Executable Recovery Memory in RTC
  • - Supports monitoring sensors in deep sleep ULP-coprocessor